How to Measure Ring Size

What you'll need:   
1. Printer & paper   
2. Scissors   

Steps:
1. Print the Printable Ring Sizing Guide. Set page scaling to "none" and confirm the paper size with the legend in our guide to guarantee accuracy.
2. Cut out the ring sizer and cut a slit as indicated by the vertical line.
3. lnsert the pointy tip of the paper through the slit so the numbers are visible to you.
4. Place the paper around the ring finger and gently tug until you have a secure, comfortable fit.
5. Make note of the number that lines up with the slit - this is your ring size!

* Keep in mind that quarter sizes are also available if your sizer indicates that you are between whole and half sizes.

What you'll need:   
1. String, yarn, floss, or a thin strip of paper    
2. Pen or marker    
3. Straight Ruler  

Steps:   
1. Measure and cut a piece of string to at least 3 inches long.
2. Wrap it around the base of the finger you plan to wear your ring on.
3. Mark where the ends overlap.
4. Lay the string flat and use a ruler to measure the length in millimeters.
5. Use the Ring Size Conversion Chart below/above to find the corresponding ring size.

What you'll need:   
1. Printer & paper
2. Scissors
3. An existing ring

Steps:   
1. Print the Printable Ring Sizing Guide. Set page scaling to "none" and confirm the paper size with the legend in our guide to guarantee accuracy.
2. Choose a ring that correctly fits the intended finger.
3. Lay the ring over each size circle within the chart until you can closely match the inside edge to one of the circles on the guide. If the ring falls between two sizes, choose the quarter size between them.